Home »
Variable Speed Generators
» Wound Rotor Induction Generators: Transients and Control
Wound Rotor Induction Generators: Transients and Control
Written By Sajib Barua on Saturday, May 31, 2014 | 5:35 AM
Subscribe to:
Post Comments (Atom)
Popular Posts
-
Figure 2.7 shows a circuit with a supply system whose open-circuit voltage is E and short-circuit impedance is , where . The load impedanc...
-
The high demand of electricity together with the continuously variable nature, and our inability to store electricity in a significant num... -
Distribution networks may be classified as either meshed or radial. However, it is customary to operate meshed networks in radial fashion... -
Power flow studies Although in reality the power network is in a continuous dynamic state, it is useful to assume that at one point the...
-
Consider a simple load R+jX with a current I and voltage V, Figure 2.6. The complex power S is defined as (2.2) S can...
-
If it is assumed that the power network is operating in steady state and that a sudden change takes place due to a faulty condition, then ... -
In power systems it is essential to keep the frequency and the voltage close to their rated values. The frequency is controlled by contr... -
Electrical power systems aim to provide a reliable service to all consumers and should be designed to cope with a wide range of normal, i.e... -
Fault level and circuit-breaker ratings The fault level (sometimes called short-circuit level) is a term used to describe the 'str...
Posts
0 comments:
Post a Comment